1. Take the Battery out of the Drone (to make sure the drone is off).
2. Reinsert the battery into the Drone.
3. Then Start DroneBlocks on the iPad (programming blocks should be visible).
4. Turn the Drone on (wait 5 seconds for the flashing orange light on the drone).
5. Go to settings on iPad and connect to Tello.
6. Then switch back to DroneBlocks (should still see all of the programming blocks).
7. Then in the upper right corner connect to Tello.
8. Should get a box with the Tello ID number and connect button and tap connect.
9. Then should bet a box with Join and click Join. 
10. After 5-10 seconds you will get the camera view thumbnail with the blocks still visible. If you click on the Thumbnail to expand the camera the programming blocks are then in a small thumbnail. Tap on the Programming blocks thumbnail to get them back to full screen and the camera view to thumbnail.